If you are a cyclist or you own a mountain bike then you definitely need a mountain bike chain lubricant, you know how hard the chain rings works. Each time we press the pedal that pushes the engine forward, the chain always operates under high voltage. First of all, the chain is an important part of the bike.
Understand your bike chain
You must know that it will go on time. Since it is a mechanical component, you must maintain it. There are three parts of the chain, namely the inner plate, chain pin and the outer plate. The pin is responsible for fixing the inner and outer plates, creating a long chain. In addition to the movement of the front and rear movements, it also has lateral movements. This is also known as lateral movement. You need a link. After a long use, the chain is extended. The increased extension also increases lateral movement (which affects movement).
How to extend the life of the chain
Clean the chain regularly. Of course, it depends on where you bike. Cyclists usually need more time to pull the rope. Use a cleaning brush and water mixed with detergents (or a degreasing agent). Tighten the gears so that the chain has the largest sprocket (most sprockets). Place the brush on the bottom of the chain and slide it with your hands. In case of stubborn dirt, use a screwdriver.
However, you also need to make sure the sprocket the chain runs on is clean. Therefore, use a toothbrush to clean the teeth of the sprocket. After you are done with cleaning your chain and sprocket teeth, you should always dry them with a cloth or rag. This keeps moisture out. In most cases, the chain and sprocket is made from steel. Keeping the moisture out will prevent rust. Why it seems important that you consider taking adequate care of your bike chain is so it does do not disappoint you when you need it the most and there is high tendency that the chain life span will be elongated.
How and when you should lubricate your chain?
Lubrication is key. Lubrication can prevent rust and other dirt problems. But only lubricate a clean chain. There is no point in lubricating a dirty chain. At least, do a quick wipe before lubricating it, if you cannot afford a full cleaning session. Experienced riders like to lube their chain one night before heading out for rides. Position the lube on the inner side of the chain and pedal backwards slowly. Make sure each roller gets lubricated. During the next morning, you should wipe off any excess from the outer plates.
Generally, you would want to get a mountain bike chain lubricant. This is especially true if you need to use your bike for a very long duration or muddy conditions. As for dry lubricants, they tend to flake off with usage and do not stay as long as wet lubes. Therefore, dry lubes are only suitable for dusty environments. This is because dry lubes and dust do not mix together.